Oxford, UK, 3-6 April 2017
- Published on Friday, 11 March 2016 15:06
The new ScientaOmicron LT-UHV scanning tunneling microscope is installed at Pico-Lab CEMES-CNRS (Toulouse) with its 4 STM scanners performing on the same surface. At 4.3 K, we report state-of-the-art STM experiments on Au(111) usually performed on the most stable single tip LT-UHV scanning tunneling microscopes.
Operating the 4 scanners independently or in parallel with an inter tip apex distance lower than 100 nm, the ΔZ stability is better than 2 pm per STM. Single Au atom manipulations were performed on Au(111) recording the pulling, sliding or pushing signal. When contacting one Au ad-atom, a jump to contact leads to a perfect linear low voltage I-V characteristics with no averaging. Two tips surface conductance measurements were also performed with one lock-in and in a floating sample mode to capture the Au(111) surface states via two STM tips dI/dV characteristics. This new instrument is exactly 4 times as precise as a single tip LT-UHV STM.
- Published on Thursday, 03 March 2016 09:35
New factors influencing particle deposition via solvent evaporation and relevant to microchips manufacturing have now been elucidated
Few of us pay attention to the minutiae of coffee stains’ deposition patterns. However, physicists have previously explained the increased deposition of ground coffee particles near the edge of an evaporating droplet of liquid. They attributed it to the collective dynamics of ground coffee grains as the liquid evaporates along the contact line between the liquid coffee and the table. This kind of dynamics also governs microchip production, when particles are deposited on a substrate by means of solvent evaporation. However, until recently, explanations of how such evaporation patterns are formed did not account for the effect of the mutual interactions between electrically charged particles. Now, Diego Noguera-Marín from the University of Granada, Spain, and colleagues have found that particle deposition may be controlled by the interplay between the evaporation of the solvent via convection and the previously identified collective diffusion of suspension nanoparticles. These findings appear as part of an EPJ E topical issue, entitled Wetting and Drying: Physics and Pattern Formation.
- Published on Wednesday, 02 March 2016 10:52
Physicists show that the shape of the air-water interface, when linked to capillarity, influences water retention or evaporation
Water in, water out: such is the cycle of porous material. In some cases, like with soils, it is preferable to keep water in. In others, it makes better economic and ecological sense to have porous materials dry faster, e.g. in the paper industries or with plasterboard manufacturing. Modeling how porous material retains water or dries up can be resolved by narrowing the focus down to a single porous channel; now, a team of physicists has uncovered subtle underlying effects. These include the local shape of the air and water interface, which, in turn, is influenced by the actual shape of the capillaries. Emmanuel Keita, a physicist from Paris-Est University, France, who is also affiliated with Harvard University, Massachusetts, USA, and colleagues have just published these results in EPJ E.
- Published on Tuesday, 01 March 2016 16:54
Scientists leave no stone unturned when studying how a liquid wets a powder
Every cook knows that dissolving powder into a liquid, such as semolina in milk or polenta in water, often creates lumps. What they most likely don’t know is that physicists spend a lot of time attempting to understand what happens in those lumps. In a review paper published in EPJ E, scientists from the École Supérieure de Physique et de Chimie Industrielles de la Ville de Paris (ESPCI), France, share their insights following ten years of research into the wetting of soluble polymer substrates by droplets of solvents like water.
- Published on Sunday, 28 February 2016 20:41
Nature of interaction of probe molecules on the surface of oxide particles elucidated
Studies of molecules confined to nano- or micropores are of considerable interest to physicists. That’s because they can manipulate or stabilise molecules in unstable states or obtain new materials with special properties. In a new study published in EPJ Plus, Stefan Frunza from the National Institute of Materials Physics in Romania and colleagues have discovered the properties of the surface layer in probe molecules on the surface of oxide particles. These properties depend on the interaction at the interface. In this particular study, probes are formed by adsorption of rod-like cyanophenyl derivates on the surface of oxide particles. The authors found that their surface layers behave like glass-forming liquids.
- Published on Tuesday, 16 February 2016 17:02
EPJ Plus has the great pleasure to announce the appointment of Professor Paolo Biscari as deputy Editor-in-Chief of the journal.
Paolo Biscari is Full Professor in Condensed Matter Physics at the Department of Physics of the Politecnico di Milano. At Politecnico di Milano he is Dean of the PhD School, which coordinates the researches of approximately 900 PhD candidates. He is Deputy Editor-in-Chief of the European Physical Journal Plus, and member of the Editorial Board of the Springer Book Series "Unitext". His research is focused in the soft matter area, and more specifically in liquid crystals, elastomers, and critical phenomena. He has been Invited Professor at the Universities of Southampton and Minnesota, has published more than 60 research papers in international peer-reviewed journals, three books, and has contributed to approximately 50 international congresses as Invited Speaker. He has directed as PI several research grants and contracts, awarded from both public Institutions and private companies. In 2004, he earned the Bruno Finzi Prize, awarded by the Istituto Lombardo, Accademia di Scienze e Lettere, for his research in Applied Mechanics.
- Published on Monday, 15 February 2016 11:29
This EPJ B Colloquium article explores applications of the Self-Consistent Random Phase Approximation (SCRPA) approach to Fermi systems with a continuously broken symmetry. Correlations beyond those considered by standard Random Phase Approximation (RPA) are summed up, thereby correcting for the quasi-boson approximation in standard RPA.
- Published on Wednesday, 03 February 2016 10:59
How the collective motion of electrons interacting with crystal atoms can be fine-tuned to harvest excess heat
At the atomic level, bismuth displays a number of quirky physical phenomena. A new study reveals a novel mechanism for controlling the energy transfer between electrons and the bismuth crystal lattice. Mastering this effect could, ultimately, help convert waste heat back into electricity, for example to improve the overall efficiency of solar cells. These findings have now been published in EPJ B by Piotr Chudzinski from Utrecht University, the Netherlands.
- Published on Tuesday, 02 February 2016 10:06
The field of microplasmas gained recognition as a well-defined area of research and applications within the larger field of plasma science and technology about 20 years ago. Since then, the level of activity in microplasma research and applications has continuously increased.
A new review article published in EPJ D provides a snapshot of the current state of microplasma research and applications. Given the rapid proliferation of microplasma-based applications, the authors focus primarily on the status of microplasma science and on current understanding of the physical principles that govern the formation and behaviour of microplasmas. They also address microplasma applications, limiting such discussion to examples where the application is closely tied to the plasma science. The article includes some key references to recent reviews, describing some of the diverse range of current and emerging applications.
- Published on Sunday, 31 January 2016 12:08
Polish team has developed equations governing the growth of authors’ h-index using an agent-based model
Scientometrics research is the science of evaluating scientific performance. Physics methods designed to predict growth based on a scale-free network have rarely been applied to this field. Now, scientists in Poland have developed an analytical method using a previously developed agent-based model to predict the h-index, probably the most popular citation-based scientific measurement, using bibliometric data. They are the very first to succeed in developing an exact formula to calculate the number of external citations and self-citations for each paper written by an author. These findings have just been published in EPJ B by Barbara Żogała-Siudem from the Systems Research Institute, Polish Academy of Sciences, Warsaw, and colleagues. It opens the door to applying this growth analysis to social network users or citations from different scientific fields.