Eur. Phys. J. B 43, 283-294 (2005)
https://doi.org/10.1140/epjb/e2005-00050-6

Ripple formation over a sand bed submitted to a laminar shear flow

Groupe Matière Condensée et Matériaux, UMR 6626, Université Rennes 1, 35042 Rennes Cedex, France

Corresponding author: ^a alexandre.valance@univ-rennes1.fr

Received: 2 September 2004
Revised: 3 December 2004
Published online: 25 February 2005

Abstract

We investigate the process of ripple formation in a viscous fluid when a sand bed is submitted to a laminar shear flow. We propose a new description for the sand transport which takes into account the fact that the transport rate does not adapt instantaneously to a change of the fluid velocity due to grain inertia. It introduces a new length, called here after equilibrium length l_eq, corresponding to the distance needed for a immobile grain to equilibrate its velocity with that of the fluid. The transport rate is therefore found to depend not only on the fluid shear stress and bed slope (as usually assumed) but also on grain inertia. Within the framework of this model we analyzed the mechanisms of the sand bed instability. It is found that the instability results from the competition between the destabilizing effect of fluid inertia and the stabilizing ones of grain inertia and bed slope. We derive analytical scaling laws for the most amplified wavelength, its growth rate and phase velocity. We found in particular that at small particle Reynolds number Re_p, the most amplified wavelength scales as the viscous length  defined as (where γ is the shear rate and ν the fluid viscosity) and at large Re_p it scales as the equilibrium length l_eq. Our results are compared with available experimental data.